RF Booster/Bracket Assembly Replacement

REMOVAL PROCEDURE
1. Remove the rear compartment trim.
2. Disconnect the following components:
- The electrical connection
- The coax cable
3. Remove the 3 mounting screws.
4. Remove the screws from the transceiver to the mounting bracket.
5. If you are replacing the brackets, remove the J-Nuts from the brackets.

INSTALLATION PROCEDURE
Use the following procedure if you are replacing the brackets or if you are installing new brackets.
1. Install the 2 J-Nuts to the upper bracket.
2. Install the 2 J-Nuts to the lower transceiver bracket.
3. Install the upper and lower brackets to the transceiver with the 2 screws on each bracket.
4. Install the transceiver to the right inner wheel housing mounting points.
5. Install the mounting screws at each mounting point until the mounting screws are secured.
6. Connect the following components:
- The electrical connection
- The coax cable
7. Install the rear compartment trim.