Disabling Theftlock (R)

Use the following sequence of operations in order to disable the theft deterrent from the secure mode:
1. Apply the battery and ignition voltages.
2. Ensure that the radio off.
3. Press the radio preset buttons 1 and 4 for 5 seconds. The display will show SEC, indicating that the unit is in the secure mode.
4. Enter the correct code number using the HR or HRS and MN or MIN buttons. The initial key press of either button causes the display to indicate 000.
5. Press and hold the MIN or MN button until the last 2 digits of the code appear. The digits will increment one by one with every momentary depression.
6. Press the HRS or the HR button until the first digit or digits of the code appear. The digits will increment one by one with each momentary depression.
7. Press the AM/FM button. If the display shows - - -, the verification was successful. The numbers match the user selected code or the factory backup code.

If the display shows SEC, the numbers did not match either of the codes, and the unit will remain in the secure state.

The display will revert to a secure state after 15 seconds.