Disc Brake Hardware Replacement - Front
Disc Brake Hardware Replacement - FrontRemoval Procedure
1. Remove the brake caliper from the mounting bracket and support the brake caliper (2) with heavy mechanic's wire (1), or equivalent. Discard the old caliper pin bolts, new bolts are supplied in the hardware kit. It is not necessary to disconnect the hydraulic brake flexible hose from the caliper.
2. Remove the brake pads (2) from the brake caliper bracket.
3. Remove the brake pad retainers (1) from the brake caliper bracket.
4. Remove the brake caliper bracket.
5. Mount the brake caliper bracket (1) in a vise.
6. Using a flat bladed tool or punch carefully remove the caliper pin boots (2) from brake caliper bracket (1) and discard.
Important: Wipe the old grease from the caliper pin bolts with a clean shop towel.
7. Inspect the brake caliper bracket for cracks. If cracked, replace bracket.
Installation Procedure
1. Apply a thin coat of NIGLUBE to the caliper guide pin (4).
2. Install new caliper pin bolt boots (2) to the caliper.
3. Install the brake caliper bracket (3).
4. Install the brake pad retainers (1) to the caliper bracket.
5. Install the brake pads (2) to the caliper bracket.
6. Remove the heavy mechanics wire (1).
7. Install the brake caliper.