Shock Module Replacement

Shock Module Replacement

Tools Required
^ J24319-B Steering Linkage and Tie Rod Puller

Removal Procedure





1. Remove the shock module upper retaining nuts.





2. Raise and support the vehicle. Refer to Vehicle Lifting.

Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.

3. Remove the tire and wheel.
4. Remove the shock module yoke to lower control arm retaining nut.





5. Remove the shock module yoke from the lower control arm using J24319-B.





6. Remove the shock module from the shock tower and lower control arm.

Installation Procedure





1. Install the shock module to the shock tower and lower control arm.
2. Install the shock module yoke to the lower control arm.
3. Lower the vehicle.





4. Install the shock module upper retaining nuts.
Tighten the shock module upper retaining nuts to 45 Nm (33 lb ft).

Notice: Refer to Fastener in Service Precautions.

5. Raise the vehicle.





6. Install the shock module yoke to lower control arm retaining nut.
Tighten the shock module yoke to lower control arm retaining nut to 110 Nm (81 lb ft).
7. Install the tire and wheel.
8. Lower the vehicle.