P1683

DTC P0601, P0602, P0603, P0604, P0605, P0606, P0607, P1600, P1621, P1627, P1680, P1681, P1683, or P2610

DTC Descriptors

DTC P0601
- Control Module Read Only Memory (ROM)

DTC P0602
- Control Module Not Programmed

DTC P0604
- Control Module Random Access Memory (RAM)

DTC P0606
- Control Module Internal Performance

Diagnostic Fault Information

Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if the ECM is not programmed.

Conditions for Running the DTC

P0601

The checksum calculation at power down in the last drive cycle completely finished. DTC P0601 runs once an ignition cycle.

P0602

The ignition is ON, with the engine OFF. DTC P0602 runs continuously.

P0604

The read/write test at power down in the last drive cycle completely finished. DTC P0604 runs once an ignition cycle.

P0606

DTC P0606 runs continuously with ignition ON or engine operating.

Conditions for Setting the DTC

P0601

The ECM detects the incorrect read only memory (ROM) checksum for more than 30 seconds.

P0602

The ECM detects that programming is incomplete for more than 1 second.

P0604

The ECM detects random access memory (RAM) errors for more than 5 seconds.

P0606

The ECM detects an internal condition for more than 5 seconds.

Action Taken When the DTC Sets

DTCs P0601, P0602, P0604, and P0606 are Type A DTCs.

Conditions for Clearing the DTC

DTCs P0601, P0602, P0604, and P0606 are Type A DTCs.

Circuit/System Verification

Ignition ON, observe the DTC information with a scan tool. DTC P0601, P0602, P0604, and P0606 should not set.

If DTC P0601 or P0604 failed this ignition, replace the ECM.
If DTC P0606 is set with P0638, P2101, or P2119, Refer to Diagnostic Trouble Code (DTC) List - Vehicle. Diagnostic Trouble Code Descriptions

Circuit/System Testing

P0602

Program the ECM. If DTC P0602 sets after programming, perform the following steps:

* Ensure that all tool connections are secure.
* Ensure the programming equipment is operating correctly.
* Ensure the correct software and the correct calibration is used.
* Attempt to program the ECM.

^ If DTC P0602 sets, replace the ECM.

P0606
1. Observe the Freeze Frame/Failure Records with a scan tool.
2. Clear the DTCs with a scan tool.
3. Ignition OFF for 30 seconds.
4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.

^ If DTC P0606 failed this ignition, replace the ECM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Control Module References for engine control module replacement, setup, and programming Programming and Relearning