Engine Oil: Service and Repair

Engine Oil and Oil Filter Replacement

Removal Procedure

1. Raise and support the vehicle.
2. Position the oil drain pan under the engine oil drain plug.




3. Remove the engine oil drain plug.
4. Clean and inspect the engine oil drain plug, repair or replace if necessary.
5. Clean and inspect the engine oil drain plug sealing surface on the oil pan, repair or replace oil pan if necessary.
6. Remove the oil filter.

Installation Procedure

1. Lightly oil the replacement oil filter gasket with clean oil and install the new oil filter.





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the new oil filter.

Tighten the new oil filter to 3/4 to 1 full turn, after the oil filter gasket contacts the oil filter mounting surface.




3. Install the engine oil drain plug.

Tighten the engine oil drain plug to 20 N.m (15 lb ft).

4. Remove the oil drain pan.
5. Lower the vehicle.
6. Fill the engine with new engine oil.
* Capacities - Approximate Fluid
* Fluid and Lubricant Recommendations