FCI (SIR)

FCI Connectors (SIR)

Removal Procedure

Note: The orange or yellow connector position assurance (CPA) must be released first to disconnect or to connect the connector.




1. Lift the orange or yellow CPA vertically (avoid lifting on an angle to the connector) approximately 4 mm to release the connector. Use a small flat-bladed tool to help release the CPA. The CPA may also be released manually without any tools.




2. Grab the connector on both sides and lift vertically to disconnect the connector.

Installation Procedure




1. The CPA should be approximately 4 mm above the yellow cover before installing the connector. If not, use a small flat-bladed tool to help release the CPA. The CPA may also be released manually without any tools.




2. Line up the connector key tabs with the initiator key slots. Grab the connector on both sides and push down into the initiator connector sub assembly until fully seated.




3. After the connector is fully seated, push the CPA down with your thumb until the CPA is touching the yellow cover on the connector.