Door Lock Switch Trim Plate

DOOR LOCK SWITCH TRIM PLATE

Trim Plate With Door Lock Switch Plate:

REMOVE OR DISCONNECT
1. Gently pry rear edge of inside remote handle cover out to disengage retaining tab. Remove handle cover.
2. Gently pry outer edge of pull strap cap away from trim plate and pull cap away from pull strap.
3. Two screws retaining top of trim plate.
4. Pull outward and up to release tabs at bottom of trim plate.
5. Electrical connectors.
6. Trim plate.

INSTALL OR CONNECT
1. Electrical connectors.
2. Engage tabs at bottom of trim plate.
3. Align lock rod with manual lock switch. Trim plate to door trim panel.
4. Two screws.
5. Tabs at inboard side of pull strap cap and press outboard side of cap to engage snap.
6. Inside remote handle cover.