Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Distributor: Service and Repair

Distributor Disassembly, Test And Reassembly - Part 1 Of 3:




Distributor Disassembly, Test And Reassembly - Part 2 Of 3:




Distributor Disassembly, Test And Reassembly - Part 3 Of 3:






REMOVE OR DISCONNECT
1. Ignition switch battery feed wire from distributor cap.
2. Ignition coil connectors from distributor cap.
3. Four (4) retainers on distributor cap and move cap out of way.
4. Six terminal PCM harness from distributor.
5. Distributor clamp nut and hold down clamp. Using J 29791 or equivalent.
6. Note position of rotor, then pull distributor up until rotor just stops turning counter clockwise and again note position of rotor.
7. Remove distributor.

INSTALL OR CONNECT
1. Distributor with rotor in same position as noted in removal step 6.
2. Hold down clamp and distributor clamp nut lightly snug.
3. Six terminal PCM harness.
4. Distributor cap.
5. Four (4) retaining bolts.
6. Ignition coil connector to cap.
7. Ignition switch battery feed wire.
8. Adjust ignition timing.
9. Tighten distributor hold-down nut using J 29791 or equivalent to 25 Nm (20 lb. ft.).