Fuse Block: Service and Repair

REMOVAL PROCEDURE
1. Remove the rear compartment front trim panel.
2. Remove the 2 nuts from the upper section of the board.
3. Remove the 2 nuts (3) from the lower section of the bay board (1).
4. Lay the bay board (1) into the rear compartment.
5. Remove any modules, as necessary.

INSTALLATION PROCEDURE
1. Install the bay board (1) to the pass-through panel.
2. Install the upper fasteners from the rear compartment.
3. Install the lower 2 fasteners (3).
4. Install the rear compartment front trim panel.