Throttle Position Sensor: Service and Repair

REMOVAL PROCEDURE

Throttle Body And Coolant Pipes:

1. Remove the rear seat cushion.

CAUTION: Refer to SIR Handling Caution in Cautions and Notices.

2. Disconnect the negative battery cable to avoid accidental starting of the engine.
3. Remove the Throttle Body Assembly.

Description:

4. Remove the TP sensor (1) mounting bolts (4) from the TP sensor.
5. Remove the TP sensor (1) from the throttle body.

INSTALLATION PROCEDURE

Description:

1. Install the TP sensor (1) on to the throttle body.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten
Tighten the TP sensor screws (4) to 2.3 N.m (20 lb in).

2. Reinstall the Throttle Body Assembly.
3. Connect the negative battery cable.
4. Reinstall the rear seat cushion.