Parking Assist Control Module: Service and Repair
Rear Object Detection Module ReplacementREMOVAL PROCEDURE
1. Remove the right rear compartment side trim.
2. Insert a small bladed screwdriver under locking tab and unlock connector.
3. Disconnect the connector from the rear object detection module.
4. Remove the mounting nuts.
5. Remove the rear object detection module.
INSTALLATION PROCEDURE
1. Install the rear object detection module.
2. Install the rear object detection module mounting nuts.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the rear object detection module mounting nuts to 9 N.m (80 lb in).
3. Install electrical connector and press in locking tab.
4. Install the rear compartment side trim.