Rear Integration Module (RIM) - Programming/RPO Configuration

Before replacing the RIM, record the personalization settings to transfer to the new module (if they are available).

After replacement of the RIM, perform the following procedure:
1. Recalibration of the automatic level control
2. Perform the vehicle personalization in order to reset the owner's desired personalization settings.

Procedure to Set Up A New RIM Module
1. Connect a scan tool to the data link connector (DLC).
2. Turn ON the ignition, with the engine OFF.
3. Under the Body Main Menu, select Rear Integration Module.
4. Under the Rear Integration Module Main Menu, select Recalibration.
5. Follow the scan tool on screen instructions in order to recalibrate the automatic level control.
6. Perform the vehicle personalization in order to reset the owner's desired personalization settings. Refer to Instrument Panel, Gauges and Console.