Bank 2 Sensor 1

Locations View:

REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the front splash shield.
3. Disconnect the front oxygen sensor electrical connector.

NOTE: Refer to Oxygen Sensor Notice in Service and Precautions.

IMPORTANT: Remove oxygen sensors with the engine temperature above 48°C (120°F). Otherwise the oxygen sensors may be difficult to remove.

4. Remove the front oxygen sensor from the front exhaust manifold.


INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service and Precautions.

IMPORTANT: A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.

1. Install the front oxygen sensor in the front exhaust manifold.

Tighten
Tighten the front HO2S sensor to 41 N.m (30 lb ft).

2. Connect the front oxygen sensor electrical connector.
3. Install the front splash shield.
4. Lower the vehicle.