Endgate Linkage Replacement

Endgate Linkage Replacement

Removal Procedure

1. Remove the operating handle.




2. Lower and support the endgate (3).
Lift the cables off the striker bolts (8).




3. Remove the three bolts holding the latch assembly (4) to the endgate.
4. Remove the latch assembly and the rod (5).



Installation Procedure





1. Install the latch assembly and the rod to the endgate.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the three bolts that hold the latch assembly (4) to the endgate.

Tighten the latch to endgate bolts to 30 N.m (22 lb ft).

3. Raise the endgate.
Attach the cables to the striker bolts.
4. Install the operating handle.