Inflatable Restraint Instrument Panel Module Replacement

REMOVAL PROCEDURE

CAUTION: Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.




1. Disable the SIR system.
2. Remove the inflatable restraint IP module cover.
3. Remove the connector position assurance (CPA) from the inflatable restraint IP module 2-way wiring harness connector (1).
4. Disconnect the inflatable restraint IP module 2-way wiring harness connector (1).
5. Remove the fasteners (2) from the inflatable restraint IP module.
6. Remove the inflatable restraint IP module (3) from the vehicle.

INSTALLATION PROCEDURE




1. Install the inflatable restraint IP module (3) to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the fasteners (2) to the inflatable restraint IP module.

Tighten
Use only hand tools to tighten the fasteners to 8 N.m ( 72 lb in).

3. Connect the inflatable restraint IP module 2-way wiring harness connector (1).
4. Install the Connector Position Assurance (CPA) to the inflatable restraint IP module 2-way wiring harness connector (1).
5. Install the inflatable restraint IP module cover.
6. Enable the SIR system.