Pressure Accumulator Switch Replacement

Pressure Accumulator Switch Replacement

Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.





2. Remove the bolts (2) that secure the Brake Pressure Modulator Valve (BPMV) (1) to the mounting bracket (3).





3. Disconnect the electrical connector from the pressure accumulator switch.





4. Position the BPMV to be able to remove the pressure accumulator switch.
5. Remove the pressure accumulator switch from the BPMV.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the pressure accumulator switch to the BPMV.
Tighten the pressure accumulator switch to 3 Nm (30 inch lbs.).





2. Connect the electrical connector to the pressure accumulator switch.





3. Install the Brake Pressure Modulator Valve (BPMV) (1) and the bolts (2) to the mounting bracket (3).
Tighten the bolts to 9 Nm (7 ft. lbs.).
4. Lower the vehicle.