Keyless Entry Receiver: Service and Repair

REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT

REMOVAL PROCEDURE
1. Turn the ignition to OFF.
2. Remove the instrument panel (I/P) trim pad.




3. Remove the retaining screws from the remote control door lock receiver.
4. Remove the receiver from the I/P carrier in order to access the wire harness connection.
5. Disconnect the wire harness connector from the door lock receiver.
6. Remove the door lock receiver.

INSTALLATION PROCEDURE




1. Connect the receiver connector and route the wire harness through the I/P carrier.
2. Line up the receiver with the hole on the retainer.
3. Install the retaining screws to the remote control door lock receiver.

Tighten the screws to 2.5 N.m (22 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the I/P trim pad.
5. Program the door lock receiver as required. Programming and Relearning
6. Program the TPM sensors. Programming and Relearning