Steering Column Lock Control Module

Steering Column Lock Control Module Replacement

Removal Procedure





Caution: Refer to SIR Caution in Service Precautions.

1. Disable the SIR system. Refer to the following procedures:
^ SIR Disabling and Enabling Zone 3
^ SIR Disabling and Enabling Zone 4
^ SIR Disabling and Enabling Zone 5

Notice: Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.

2. Remove the I/P carrier.
3. Disconnect the electrical connectors at the lock module.





4. Remove the lock module by pulling the module up to release the retaining clips and sliding the module upward.

Installation Procedure





1. Install the control module to the retaining bracket on the steering column.
2. Connect the electrical connector to the lock module.





3. Install the I/P carrier.
4. Enable the SIR system. Refer to the following procedures:
^ SIR Disabling and Enabling Zone 3
^ SIR Disabling and Enabling Zone 4
^ SIR Disabling and Enabling Zone 5
5. Program the lock control module.