Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

CAMSHAFT POSITION SENSOR REPLACEMENT - BANK 2 (LEFT SIDE) INTAKE

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield.
2. Disconnect the electrical connector from the left bank intake camshaft position sensor (1).

IMPORTANT: When disconnecting more than one sensor, mark the connectors to ensure correct re-installation. The electrical connectors are physically interchangeable, however, they must be installed to the correct sensor.




3. Remove the camshaft sensor retaining bolt.
4. Remove the left bank intake camshaft sensor (3).

INSTALLATION PROCEDURE




1. Lubricate the camshaft sensor O-ring with engine oil.

IMPORTANT: Inspect the camshaft sensor O-ring for wear or damage. If a problem is found, replace the O-ring.

2. Install the left bank intake camshaft position sensor (3) and retaining bolt.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the retaining bolt to 10 N.m (89 lb in).




3. Reconnect the camshaft sensor electrical connector (1).
4. Install the fuel injector sight shield.
5. Operate the engine and inspect the camshaft sensor for engine oil leaks.