Operation CHARM: Car repair manuals for everyone.
Home >> Cadillac >> 2007 >> SRX RWD V6-3.6L >> Repair and Diagnosis >> Testing and Inspection >> Programming and Relearning >> Electronic Suspension Control Module Programming and Setup
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Electronic Suspension Control Module Programming and Setup



Electronic Suspension Control Module Programming and Setup

ESCM Replacement

If the electronic suspension control module (ESCM) is replaced, the procedures must be perform in the following order:

1. The ESCM programming, refer to Service Programming System (SPS). Programming and Relearning
2. The bumpstop setup procedure. To perform this procedure, lift the vehicle just off the ground to fully extend the suspension. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instructions in ESC Special Functions.

Important: The vehicle must be at correct trim height and on a level surface before performing trim set procedure. Refer to Trim Height Inspection.

3. The trimset procedure. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instruction in the ESC Special functions.

ESCM Programming

If the ESCM is reprogrammed, the procedures must be performed in the following order:

1. The ESCM reprogramming, refer to Service Programming System (SPS). Programming and Relearning
2. The bumpstop setup procedure. To perform this procedure, lift the vehicle just off the ground to fully extend the suspension. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instructions in ESC Special Functions.

Important: The vehicle must be at correct trim height and on a level surface before performing trimset procedure. Refer to Trim Height Inspection.

3. The trimset procedure. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instruction in the ESC Special functions.

Suspension Position Sensor Replacement

If a position sensor is replaced, the procedures must be performed in the following order:

1. The bumpstop setup procedure. To perform this procedure, lift the vehicle just off the ground to fully extend the suspension. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instructions in ESC Special Functions.

Important: The vehicle must be at correct trim height and on a level surface before performing trimset procedure. Refer to Trim Height Inspection.

2. The trimset procedure. Connect the scan tool to the vehicle, turn ignition ON with the engine OFF, and follow the on screen instruction in the ESC Special functions.

pro multis · About Operation CHARM