Operation CHARM: Car repair manuals for everyone.
Home >> Cadillac >> 2007 >> STS RWD V6-3.6L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Oxygen Sensor >> Service and Repair >> Heated Oxygen Sensor Replacement - Bank 2 Sensor 1
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Heated Oxygen Sensor Replacement - Bank 2 Sensor 1



Heated Oxygen Sensor Replacement - Bank 2 Sensor 1

Removal Procedure




1. Turn the ignition OFF.
2. Remove the fuel injector sight shield, if necessary.
3. Raise and support the vehicle. Refer to Vehicle Lifting in General Information.
4. Disconnect the heated oxygen sensor (HO2S) electrical connector.
5. Remove the HO2S electrical connector from the wiring harness bracket.






Notice: Refer to Oxygen Sensor Notice in Cautions and Notices.

Important: Removal of the oxygen sensor is easier when the engine temperature is above 48°C (120°F).

6. Remove the HO2S.

Installation Procedure






Notice: Refer to Component Fastener Tightening Notice in Cautions and Notices.

Important: New oxygen sensors should have a special anti-seize compound already applied to the sensor threads. If you are installing the original sensor, apply anti-seize compound GM P/N 5613695 or equivalent to the sensor threads.

1. Install the HO2S.

Tighten the HO2S to 40 N.m (30 lb ft).




2. Install the HO2S electrical connector to the wiring harness bracket.
3. Connect the HO2S electrical connector.
4. Lower the vehicle.
5. Install the fuel injector sight shield, if necessary.
pro multis · About Operation CHARM