Transmission Fluid Level Inspection

Transmission Fluid Level Inspection





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Clean any dirt from around the fill plug (1).
3. Remove the transmission fill plug (1) and washer (2) from the transmission.




4. Check that the transmission fluid level is even with the bottom of the fill plug hole.
5. Add transmission fluid, if necessary.




6. Inspect the fill plug washer (2) and replace if necessary.

Notice: Refer to Component Fastener Tightening Notice (Component Fastener Tightening Notice) .

7. Install the transmission fill plug (1) and washer (2).

Tighten the transmission fill plug to 37 N.m (27 lb ft).

8. Lower the vehicle.