Operation CHARM: Car repair manuals for everyone.
Home >> Cadillac >> 2008 >> SRX AWD V8-4.6L >> Repair and Diagnosis >> Body and Frame >> Seats >> Service and Repair >> Removal and Replacement >> Seat Horizontal Adjuster Cable Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Seat Horizontal Adjuster Cable Replacement



Seat Horizontal Adjuster Cable Replacement

Removal Procedure





Caution: Refer to SIR Caution (SIR Caution) .
1. Disable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) .
2. Remove the seat assembly. Refer to Bucket Seat Replacement (Bucket Seat Replacement) .
3. Remove the seat cushion to gain access to the horizontal seat adjuster motor. Refer to Front Seat Cushion Replacement (Front Seat Cushion Replacement) .
4. Disconnect the electrical connectors from the motor.
5. Remove the screws from the top of the adjuster motor.
6. Remove the seat adjuster drive cable (1) by pulling the cable out of the motor.
7. Remove the seat adjuster motor .
8. Remove the short drive cable from the seat adjuster.



Installation Procedure

1. Position the short drive cable into the seat adjuster.
2. Line up the square end of the cable with the motor.
3. Slide the motor on to the cable.




4. Install the long drive cable (1) into the motor.
5. Install the long cable into the seat adjuster.
6. Ensure that both cables are fully seated.

Notice: Refer to Fastener Notice (Fastener Notice) .

7. Install the motor retaining screws.

Tighten the screws to 5 N.m (44 lb in).

8. Connect the electrical connectors.
9. Install the seat cushion. Refer to Front Seat Cushion Replacement (Front Seat Cushion Replacement) .
10. Install the seat assembly. Refer to Bucket Seat Replacement (Bucket Seat Replacement) .
11. Enable the SIR system. Refer to SIR Disabling and Enabling (Service and Repair) .
12. If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration (Programming and Relearning) .


pro multis · About Operation CHARM