Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Replacement

Removal Procedure

1. Turn the ignition OFF.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




3. Remove the exhaust manifold heat shield to obtain access.




4. Disconnect the crankshaft position (CKP) electrical connector (3).




5. Remove the crankshaft sensor bolt.
6. Remove the crankshaft sensor.

Installation Procedure




1. Install the crankshaft position sensor.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the crankshaft position sensor bolt and tighten to 10 Nm (89 lb in).




3. Connect the CKP electrical connector (3).




4. Install the exhaust manifold heat shield and tighten to 10 Nm (89 lb in).
5. Lower the vehicle.