Removal and Replacement

1. Disconnect battery ground cable.

2. Disconnect T.V. cable at upper end, then remove transmission oil dipstick

3. Raise and support vehicle.

4. Disconnect speedometer cable, shift linkage, and all electrical leads at transmission as well as any clips that retain the leads to transmission case.

5. Remove flywheel cover, then mark flywheel an torque converter to maintain original balance. Remove torque converter to flywheel bolts and/or nuts.

6. Remove exhaust system.

7. Install suitable jack under transmission, then raise transmission slightly.

8. Remove driveline beam and propeller shaft

9. Lower transmission to gain access to the oil cooler lines and T.V. cable attachments, then disconnect oil cooler lines and T.V. cable and cap all openings.

10. Support engine using suitable jack then remove transmission to engine attaching bolts.

11. Separate transmission assembly from engine, then install torque converter holding tool No. J-21366 and lower transmission from vehicle.

12. Reverse procedure to install.