Installation

Fig. 2 Installing bearings in rotor. Nippondenso 10 cylinder:

1. Using SST No. 07110-77011 or equivalent, press shield ring and two new bearings into pulley boss until fully seated, Fig. 2.
2. Install bearing snap ring into groove in pulley.
3. Install stator on compressor and install snap ring retaining stator.
4. Connect stator lead wires to compressor housing.
5. Install pulley on compressor shaft and install snap ring retaining pulley.
6. Adjust clearance between pressure plate and pulley by installing shims on compressor shaft.
7. If clearance is not within .016-.028 inch, adjust it by adding or removing shims until correct clearance is obtained.