Service Procedure

EXISTING GENERATOR ASSEMBLY:

WIRING INDICATIONS:

1. Disconnect negative battery cable.

2. Cut red wire five (5) inches back from two-way connector at generator (see Figure 2, #1). Add ring terminal, P/N 2977489, to wire and solder.
3. Tape other end of wire and place in conduit (see Figure 2. #3).

REWORKED GENERATOR ASSEMBLY:

4. Remove cover from generator terminal (see Figure 3, #1).

5. Remove nut from generator stud (see Figure 3, #2). Connect ring terminal from red wire to stud, reinstall nut and torque to 6.0 N.m (4.5 ft.lb.). Replace cover.

6. Reconnect negative battery cable.

7. Install Campaign Identification Label.

CAMPAIGN IDENTIFICATION LABEL:

CAMPAIGN IDENTIFICATION LABEL

Each vehicle modified in accordance with the instructions outlined in this Product Campaign Bulletin will require a "Campaign Identification Label." Each label provides a space to include the five digit dealer code of the dealer performing the campaign service. This information may be inserted with a typewriter or ballpoint pen.
Each "Campaign Identification Label" is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for periodic servicing by the owner.

Apply "Campaign Identification Label" only on a clean dry surface.