Removal

Fig. 1 Exploded view of compressor clutch assembly. Nippondenso 10 cylinder:

1. Using socket and suitable holding device, remove shaft nut, Fig. 1.
2. Using socket and tool SST No. 07112-77010, or equivalent, remove pressure plate.
3. Remove shims from shaft.
4. Using suitable snap ring pliers, remove snap ring retaining pulley.
5. Remove pulley from shaft by carefully tapping with plastic hammer.
6. Disconnect stator lead wires from compressor housing.
7. Using suitable snap ring pliers, remove snap ring retaining stator, then remove stator.
8. Remove bearing snap ring from pulley.
9. Using SST No. 07110-77011 or equivalent, press out two bearings.