Service Procedure

SERVICE PROCEDURE - Numbers in parethesis refer to figure.

1. Disconnect negative ground cable from battery.

2. Remove engine cover and disconnect front fuel return line (1) from injector fuel return pipe.

3. Raise vehicle up on hoist.

4. Disconnect front fuel return line (1) from rear fuel return pipe at left hand frame. Drain excess fuel into an available container.

5. Remove fuel line clip (7) at bottom of filter (4).

6. Remove fuel filter clamp mounting screw (6) and slide front fuel return line (1) out of clamp (5).

7. Install now front fuel return line (1) in clamp (5) and loosely install clamp mounting screw (6).

8. Reconnect front fuel return line (1) to rear return line and to injector fuel return line. Torque connections to 20-34 N-m (15-25 lb.ft).

9. Reinstall fuel line clip (7).

10. Tighten filter clamp screw (6) to 9-13 N-m (80-115 lb.in).

11. Lower vehicle.

12. Reconnect battery negative ground cable. Operate engine and check fuel line connections for leakage.

13. Reinstall engine cover.

14. Install "Campaign Identification Label".