Access Cover: Service and Repair

ENGINE COVER REPLACEMENT











Remove or Disconnect (Figures 55 and 56)
1. Instrument panel lower extension screws (150), washers (151), and shims (152).
2. Instrument panel lower extension (153).
3. Engine cover to door panel bolts (156).
4. Clamp (157) from the pin (155).
5. Engine cover (158) from the vehicle.

Install or Connect (Figures 55 and 56)
1. Engine cover (158) to the vehicle.
2. Clamp (157) to the pin (155).
3. Engine cover to floor panel bolts (156).
4. Instrument panel lower extension (153).
5. Instrument panel lower extension screws (150), washers (151) and shims (152).

INSTRUMENT PANEL LOWER EXTENSION COMPARTMENT DOOR LOCK REPLACEMENT











Remove or Disconnect (Figure 51)
1. Instrument panel lower extension screws and washers (figure 55).
2. Instrument panel lower extension (153) from the vehicle.
3. Lock cylinder (159) from case assembly (162).
- Pull down spring pin on case assembly (162) so that it is in the open position.
- From inside of instrument panel lower extension, depress brass retaining pin on lock cylinder by inserting a pointed tool into hole on case assembly.
While depressing brass retaining pin, pry up on lock cylinder from outside of compartment door using a flat-bladed tool.
- Hold down spring pin on case assembly and remove lock cylinder using a wiggling motion.
Install or Connect
1. Lock cylinder (159) to case assembly (162).
- Align brass retaining pins on lock cylinder to opening in case assembly.
- Hold down spring pin on case assembly and insert lock cylinder until it is fully seated in case.
2. Instrument panel lower extension cover (153) to engine cover.






3. Instrument panel lower extension cover washers and screws (figure 55).