Test B Power Circuit Open Test

TEST B: POWER CIRCUIT OPEN TEST

1. Check GAGES Fuse.

2. Check that terminal J (BLK) of the Cruise Control Module is grounded.

3. Disconnect C211 and check for battery voltage at terminal M (PNK/BLK) of the harness half with Ignition in RUN (see schematic).

^ If battery voltage is missing, check/repair PNK/BLK (39) wire.

4. Check continuity between terminals M and L of the pin half of connector C211 with the Cruise Switch ON.

^ If the Switch is open, replace the Multi-Function Lever.

5. Check for an open in GRY (397) wire between terminal L of connector C211 and terminal A of the module connector.