1ST/2ND Blocker Rings

1. Install three-piece 1st gear blocker ring assembly using a twisting motion to fully seat.

2. Install three-piece 1st gear blocker ring assembly, with needle bearing and bearing sleeve, to first gear.

3. Install three-piece 2nd gear blocker ring assembly using a twisting motion to fully seat.

4. Install three-piece 2nd gear blocker ring assembly, with thrust washer, to 2nd gear.

5. Measure gap between vertical faces of blocker teeth and clutch teeth. Nominal gap is 0.O32-0.O55 inch for new blocker ring assemblies.