Caliper Installation

Fig. 5 Removing Caliper Mounting Bolts:

Fig. 12 Checking Clearance Between Caliper & Stops:

1. Position caliper assembly over disc and align mounting bolt holes. If brake hoses were not disconnected during removal, use care not to kink hoses during installation.
2. Install mounting bolts and tighten to specifications, Fig. 5.
3. Check the dimensions between each caliper stop and caliper, Fig. 12. If necessary remove caliper and file ends of bracket to provide proper clearance.
4. If brake hose fitting was disconnected during removal, install brake hose fitting.
5. Fill master cylinder. Bleed brake system if brake line was disconnected and recheck master cylinder fluid level.
6. Install wheel and tire assembly on vehicle, then lower vehicle and check brake system operation. Before moving vehicle, pump brake pedal several times to be sure it is firm. Do not move vehicle until a firm pedal is obtained.