Ignition Coil: Service and Repair

REMOVAL:

NOTE: Make sure ignition switch is "OFF".

- Disconnect wiring connectors at side of the coil.
- Disconnect coil to distributor lead at coil.
- Remove nuts or screws holding coil bracket and coil to engine.
- Remove coil bracket and coil.
- Drill and punch out rivets holding coil to coil bracket.
- Remove coil from coil bracket.

INSTALLATION:

- Install coil to coil bracket with screws.
- Install coil and coil bracket to engine. Tighten screws to 22 N-m (16 lb. ft.).
- Connect distributor lead to coil .
- Connect wiring connectors to the coil.