Manual Regulator

Door Window Components:

Remove or Disconnect

^ Raise the window and tape the glass in the full up position using cloth body tape.
1. Door trim panel.
2. Door panel to regulator bolts (237).
3. window regulator (238).
^ Slide the regulator rearward to disengage the rear roller from the sash channel. Also disengage the lower roller from the regulator rail.
^ Disengage the forward roller from the sash channel at the notch in the sash channel.
^ Collapse the regulator; and remove it through the access hole in the door.

Install or Connect

^ Lubricate the regulator and the sash and regulator rails with Lubriplate(R) or equivalent.
1. Window regulator (238).
^ Collapse the regulator, and insert It through the access hole in the door.
^ Unfold the regulator, and engage the forward roller to the sash channel at the sash channel notch.
^ Slide the regulator rearward to engage the rear roller to the sash channel. Also engage the lower roller to the regulator rail.
^ Slide the regulator into its proper Position and insert the regulator drive through the door panel.
2. Door panel to regulator bolts (237).

Tighten
^ Regulator bolts to 9.5 N.m (84 in. lbs.).

^ Remove the tape from the window.