Camshaft Position Sensor: Service and Repair

Camshaft Position Sensor:

REMOVE OR DISCONNECT
1. Be sure ignition switch is in "OFF" or "LOCK" position.
2. Electrical connector from camshaft position sensor.
3. Bolt/screw mounting camshaft position sensor to front cover.

CAUTION: Be careful not to damage sensor when prying at its base during removal.

4. Sensor using a small-bladed screwdriver to gently pry between sensor and front cover. Pry from alternate sides to loosen sensor in its mounting boss.

INSPECT
Sensor 0-ring for wear, cracks or leakage. Replace if necessary.

INSTALL OR CONNECT
1. Lubricate sensor 0-ring with engine oil.
2. Camshaft position sensor to front cover.
3. Bolt/screw mounting camshaft position sensor to front cover. Tighten to 10 Nm (89 in lb).
4. Electrical connector to camshaft position sensor.