Ignition Cable: Service and Repair

NOTICE: The boots should be twisted one-half turn while removing. Do not pull on the wire harnesses to remove them from the spark plugs. Pull on the boots, or use a tool designed for this purpose.

REMOVE OR DISCONNECT
1. Be sure ignition switch is in OFF or LOCK position.
2. Raise and suitably support vehicle.
3. Power steering pump assembly.
4. Crossover pipe from exhaust manifold assemblies.
5. Lower radiator hose from water pump.
6. Spark plug wire harness from wire harness clips.
7. Spark plug wire harness from distributor.
8. Spark plug wire harness from spark plugs.
^ Note position of wires before removing.

INSTALL OR CONNECT
1. Spark plug wire harness to spark plugs.
2. Spark plug wire harness to distributor.
3. Spark plug wire harness to wire harness clips.
4. Lower radiator hose to water pump.
5. Crossover pipe to exhaust manifold assemblies.

Tighten
^ Crossover pipe to exhaust manifold nuts to 35 Nm (26 lb. ft.).

6. Power steering pump assembly.
7. Lower vehicle.