Front

1. Raise and support vehicle.
2. Remove tire and wheel assembly.
3. Remove caliper.
4. Remove grease cap from hub/rotor.
5. Remove cotter pin, nut and washer.
6. Remove hub/rotor from spindle, being careful not to damage spindle threads or outer bearing.
7. Reverse procedure to install, noting the following:
a. Apply high-temperature wheel bearing grease to inner and outer wheel bearings.
b. Torque nut to 12 ft. lbs. while turning wheel assembly forward by hand, back nut off one flat or until hole in spindle lines up with hole in nut, then insert cotter pin.