Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 1996 >> Camaro V6-3.8L VIN K >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Ignition Cable >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Ignition Cable: Service and Repair

Spark Plug Wire Harness Routing:






CAUTION: The boots should be twisted one-half turn while removing. DO NOT pull on the wires to remove them from the spark plugs. Pull on the boots, or use a tool designed for this purpose.

REMOVE OR DISCONNECT
1. Be sure ignition is in "OFF" or "LOCK" position.
2. Spark plug wire harness from wire harness retainers.
3. Spark plug wire harness from ignition control module.
4. Spark plug wire harness from spark plugs.

TIP: Note position of wires before removing them from vehicle.

INSTALL OR CONNECT
1. Spark plug wire harness to spark plugs.

NOTE:To complete installation of heat shield and boot to spark plug, lower tabs of heat shield must extend over hex on spark plug.

2. Spark plug wire harness to ignition control module.
3. Spark plug wire harness to wire harness retainers.
pro multis · About Operation CHARM