Fuel Filter: Service and Repair

REMOVAL PROCEDURE

NOTE: If the in-line filter is plugged, the fuel tank should be inspected internally and cleaned if necessary.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure. Service and Repair
3. Disconnect the fuel feed pipes at the filter.
4. Remove the in-line fuel filter clamp attaching hardware.
5. Remove the clamp from the filter.

INSTALLATION PROCEDURE
1. Remove the protective caps from the new filter.
2. Install the clamp to the filter.
3. Install the in-line filter clamp attaching hardware.

NOTE: Install in the same positions as on the old filter noting direction of fuel flow arrow.

4. Connect the fuel feed pipes to the filter and tighten.
5. Connect the negative battery cable.
6. Inspect for fuel leaks.

6.1. Turn ON the ignition switch for 2 seconds.
6.2. Turn OFF the ignition switch for 10 seconds.
6.3. Again, turn the ignition switch to the ON position.
6.4. Check for fuel leaks.