Front A/C Unit

Heater Control Assembly:

Heater Control Vacuum And Electrical Harness:

Remove or Disconnect

1. Instrument cluster trim bezel.
2. Control assembly from I/P.
- One retaining screw from left edge of control assembly.
- Pivot control assembly from the I/P.
- Pull control assembly out of the instrument panel far enough to reach the vacuum and electrical connectors.
3. Electrical connectors.
4. Vacuum connectors.

Install or Connect

1. Vacuum connectors.
2. Electrical connectors.
3. Control assembly to the I/P.
4. Electrical connectors.
5. Vacuum connectors.
6. Control assembly to I/P.
- Pivot assembly on the right end into the I/P.
- One retaining screw to the left edge of control assembly.