Accessory Switch Plate and Switch Mount Plate

Accessory Switch Mount Plate W/ Lock Lever Escutcheon:

Remove or Disconnect

1. Two screws and armrest cover (YC5 only).
2. Window handle, if equipped.
3. Lock lever escutcheon by pulling out, starting with the front edge.
4. Upper corner trim by pulling out at top edge and pivoting down to clear tab at trim panel (YC6 and YC7 only).
5. Two caps covering the screws retaining the assist handle.
6. Two screws retaining the handle to the door.
7. One screw at front edge of accessory switch mount plate.
8. Plate from trim panel.
9. Electrical connectors from switches on plate, as necessary.

Install or Connect

1. Electrical connectors to switches on the accessory switch mounting plate, as necessary.
2. Plate to the trim panel.
3. One screw at front edge of accessory switch mount plate.
4. Handle to the door with two screws.

Tighten
^ Screws to 5 N.m (44 lb in).

5. Two caps covering the screws on the assist handle.
6. Upper corner trim by insert tab in slot on door trim panel and seating the fastener into the door at the top (YC6 and YC7).
7. Lock lever escutcheon by snapping into place, starting at the rear edge.
8. Window handle, it equipped.
9. Armrest cover with two screws (YC5 only).