Cruise Control Cable

REMOVE OR DISCONNECT
1. Cable (14) and conduit from engine bracket.
2. Cable end fitting from throttle body lever stud.
3. Cruise control retainer (18) at cruise control module.
4. Cable (14) from cruise control module (11).
A. Compress conduit tangs and pull out of cruise control module housing. (11).
B. Disconnect cable bead from cruise motor band end fitting on cruise control module (11).
C. Note routing and remove cable (14) from vehicle.

INSTALL OR CONNECT
1. Cable (14) to cruise control module (11).
A. Attach cable bead to cruise motor ribbon end fitting on cruise control module (11).
B. Pull engine end of cable (14) until it is taut.
C. Turn engine end of cable until ribbon is flat.
Important
^ Ribbon must not be twisted.
- Slide cable conduit fitting over ribbon and snap into module housing assuring that both tangs are engaged.
2. Cruise control retainer (18) at cruise control module (11).
3. Cable (14) to vehicle.
^ Use routing noted during removal.
4. Cable end fitting to throttle body lever stud.
Important
^ Install slug of cable to cam of throttle body before installing cable and conduit to the engine bracket. Be careful not to bend the corewire of the cable when installing the slug to the cam.
5. Cable (14) and conduit to engine bracket.
Adjust
^ Cable. Refer to "Cable Adjustment".