Forward Clutch Assemble

- Tools Required:
- J 21362-1 Inner Seal Protector
- J 38732- 1 Outer Seal Protector
- J 23327 Spring Compressor
- J 25018-A Compressor Adaptor
- J 36850 TRANSJEL (TM)
- Or Equivalent





1. Lubricate the piston seal with DEXRON(R) III transmission fluid.
2. Lubricate the center seal with DEXRON(R) III transmission fluid.
3. Install the J 21362-1 over the forward clutch housing hub.
4. Place the forward clutch piston (606) inside J 38732-1 and insert the assembly into the forward clutch housing assembly (602).
5. Push down on and slightly rotate the piston until it is seated.
6. Remove the tools.





7. Install the forward clutch spring (607).
8. Compress the forward clutch spring (607) using the J 23327 and J 25018-A.
9. Install the forward clutch spring retainer ring (608).
10. Remove the J 23327.





11. Dip the clutch plates in DEXRON(R) III transmission fluid.
12. Install the forward clutch apply clutch plate (609).
13. Install the steel and composite forward clutch plates (610, 611). Starting with the steel clutch plate, alternate the clutch plates.

Important: The forward clutch hub and thrust washer should not be installed at this time. This will allow easier access in order to perform the forward clutch piston travel check.

14. Install the direct clutch hub retainer ring (615).