Compressor Clutch Coil: Service and Repair

Tools Required:
J 33023-A Puller Pilot
J 33020 Pulley Puller
J 34992 Compressor Holding Fixture
J 8433-1 Puller Bar
J 8433-3 Forcing Screw
J 33025 Clutch Coil Puller Legs
J 33024 Clutch Coil Installer


Remove or Disconnect

1. Drive belt.
2. Passenger-side electric cooling fan.
3. Install a piece of cardboard where electric cooling fan was to protect radiator.
4. Raise vehicle and suitably support.
5. Passenger-side tire and wheel.
6. Passenger-side engine splash shield.
7. A/C compressor pulley.
8. Electrical connector from compressor.
9. Compressor mounting bolts and lay compressor on the frame.
10. Install J 8433-1, J 8433-3, J 33025, and J 33023-A onto A/C clutch coil. Tighten center screw of puller bar until A/C clutch coil comes off.
11. J 8433-1, J 8433-3, J 33025, and J 33023-A along with A/C clutch coil.

Install or Connect

1. J 34992 around compressor.
2. A/C clutch coil in place.
3. J 8433-1, J 8433-3, and J 33024 onto A/C clutch coil and to J 34992 with mounting bolts. Tighten center screw of puller bar until it pushes the A/C clutch coil all the way down.
4. Remove J 8433-1, J 8433-3, and J 33024.
5. A/C compressor pulley.
6. Compressor with mounting bolts.

Tighten
^ Bolts to 50 N.m (37 lb. ft.).

7. Electrical connector to compressor.
8. Passenger-side engine splash shield.
9. Passenger-side tire and wheel.
10. Lower vehicle.
11. Remove the piece of cardboard.
12. Passenger-side electric cooling fan.
13. Drive belt.