Generator Pulley

TOOL REQUIRED:
J 35669 Strut Rod Nut Remover and Installer

REMOVE OR DISCONNECT
1. Drive belt from generator.
2. Generator rotor shaft drive end nut using J 35669.
3. Generator pulley washer.
4. Generator pulley from generator.

INSTALL OR CONNECT
1. Generator pulley to generator.
2. Generator pulley washer.
3. Generator rotor shaft drive end nut using the J 35669.
Tighten
^ Nut to 70 N.m (52 lb. ft) with Valeo A13VI+ (K68).
^ Nut to 100 N.m (74 lb. ft.) with Delphi CS144 (KG9).
4. Drive belt to generator.