Crankshaft Position Sensor Replacement

Crankshaft Sensor:

REMOVAL PROCEDURE
1. Disconnect the CKP sensor harness electrical connector at the CKP sensor.
2. Remove the CKP sensor to engine block bolt.
3. Remove the CKP sensor from the engine block.

INSTALLATION PROCEDURE

IMPORTANT: Inspect the CKP sensor O-ring for wear, cracks or leakage. Replace if necessary. Lubricate the new O-ring with engine oil before installing.

1. Install the CKP sensor into the engine block.
2. Install the CKP sensor to engine block bolt. Tighten the bolt to 10 Nm (88 lb in).
3. Connect the CKP sensor harness electrical connector.
4. Perform the Crankshaft Position System Variation Learning Procedure.