Operation CHARM: Car repair manuals for everyone.
Home >> Chevrolet >> 1998 >> Corvette V8-5.7L VIN G >> Repair and Diagnosis >> Brakes and Traction Control >> Hydraulic System >> Brake Fluid Pressure Sensor/Switch >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Brake Fluid Pressure Sensor/Switch: Service and Repair



REMOVAL PROCEDURE
1. Turn the ignition switch to the OFF position.
2. Disconnect the Brake Pressure Sensor connector.





3. Remove the Brake Pressure Sensor (3).

INSTALLATION PROCEDURE





1. Make sure the O ring (1) is installed properly on the Brake Pressure Sensor (2).





2. Install the Brake Pressure Sensor (3).
- Tighten the Brake Pressure Sensor to 18 Nm (13 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Connect the Brake Pressure Sensor connector.
4. Turn the ignition switch to the ON position, engine off.
5. Perform the Hydraulic Brake System Bleeding (Pressure) in Hydraulic Brakes.
6. Perform the Diagnostic System Check (ABS).
pro multis · About Operation CHARM