Engine Flywheel Installation

1. Note the position of the flywheel weights (manual transmission applications), install the NEW flywheel weights as required.
A properly installed flywheel weight should be installed until flush or below flush with the face of the engine flywheel.

IMPORTANT: If replacing the engine flywheel (manual transmission), note the position of the original flywheel weights (if applicable). Flywheel weights must be installed into the new engine flywheel (manual transmission) in the same location.





2. Install the engine flywheel.
Align the engine flywheel locator hole to the flywheel locator pin.





3. Install the engine flywheel bolts.
- Tighten the engine flywheel bolts in sequence (1-8) to 100 Nm (74 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.